COMPONENTS
AC Source
3-W
Transformer
Thyristor
Gate Pulse
Voltmeter
Ammeter
Resistor
Inductor
Ground
OBSERVATION TABLE
| S.No. | VLrms (V) | ILrms (A) | VLavg (V) | ILavg (A) |
|---|
10
11
VT1
12
13
14
T1
15
GP1
VGP1
16
17
18
GND1
VINP
1
2
3
4
AC
5
6
7
8
9
3-W
Transformer
19
20
R
21
22
L
23
24
IL
25
26
VLOAD
27
28
VT2
29
30
31
T2
32
GP2
VGP2
33
34
35
GND2
WAVEFORM
- STEP 1: Drag and drop the components in the workspace to create the circuit.
- No. of required components:
- AC Source – 1, 3-W Transformer - 1, Thyristor - 2, Gate Pulse - 2,
- Voltmeter – 6, Ammeter - 1, Resistor - 1, Inductor - 1, Ground – 2
- STEP 2: Make the connections as per the instructions given below:
- (a) (01-03, 02-04, 03-05, 04-06, 07-12)
- (b) (10-12, 11-13, 13-24, 14-15, 15-16)
- (c) (17-18, 08-19, 20-21, 22-23, 19-25)
- (d) (22-26, 09-29, 27-29, 28-30, 24-30)
- (e) (31-32, 32-33, 34-35)
- Note: Click on the wire to delete the connection.
- STEP 3: Click on the CHECK button to check the connections.
- Note: Right click on the component to open the dialog box to edit the properties of the component.
- STEP 4: Input the values for all the required components (AC Source, Gate Pulses, Resistor and Inductor) and the waveform will get plot automatically.
- STEP 5: Now, Click on the ADD button to insert the reading into the observation table.
- STEP 6: Now, you can input different values as per your requirement to get the desired waveform.
- STEP 7: Repeat Step 5 to again insert the reading into the table and now repeat Steps 6 to 7 to take more readings.
- STEP 8: Click on the PRINT button to take out the print of the webpage.
- STEP 9: Click on the RESET button to reload the webpage.
